TotalBoat Aluminum Boat Etch Wash cleans, brightens, and improves the adhesion of topcoats applied to aluminum, galvanized steel, and other non-ferrous metals. Applying a single coat removes corrosion and etches the surface so finishes bond stronger and last longer. Compatible with one- and two-part finishes, Aluminum Boat Etch Wash may be used above or below the waterline.

Surface Preparation

Preparation for Painting or Polishing Aluminum

Remove any loose dirt or debris from the metal surface.

Preparation for Applying Epoxy to Aluminum

Remove any loose dirt or debris from the metal surface. Abrade with a Scotch-Brite™ pad or sand the surface with 220-grit sandpaper, then remove any sanding residue.

Application

1. Avoid bodily contact with TotalBoat Aluminum Boat Etch Wash and always use a proper apron, rubber gloves, and goggles when applying or working with Aluminum Boat Etch Wash.
2. TotalBoat Aluminum Boat Etch Wash is ready to use and can be applied by brush or spraying. Any oxidation buildup can be removed by abrading the area lightly with a Scotch-Brite pad.
3. Do not allow Aluminum Boat Etch Wash to dry on the metal during application. Reapply as needed to prevent drying.
4. After 5 minutes, remove Aluminum Boat Etch Wash from the surface by rinsing thoroughly with fresh or deionized water.

Notes: For best results coating the metal, dry the surface completely and apply paints, primers, epoxy, or polish immediately after application.

Application Data

Physical Data