Lindsay Eckenrode
- Total activity 89
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 10
Activity overview
Latest activity by Lindsay Eckenrode-
Lindsay Eckenrode created an article,
What is the minimum cure time for light use on either ThickSet or Artist Resin?
The minimum cure time for TotalBoat ThickSet Cast + Coat Deep Pour Epoxy and TotalBoat Artist Resin at 65°F to 75°F is 48 hours. { "@context": "https://schema.org", "@type": "FAQPage", "mainEntity"...
-
Lindsay Eckenrode created an article,
How long does high performance need to cure before it can be sanded?
At 77°F, TotalBoat Clear High Performance Epoxy can be sanded after approximately 16 hours when using Slow Hardener, 12 hours with Medium Hardener, and 6 hours with Fast Hardener. Cooler temperatur...
-
Lindsay Eckenrode created an article,
Do we sell a EPA approved bottom paint?
EPA-approved marine antifouling paints include widely used, regulated options that control copper leaching or use alternative biocides to protect against marine growth. All paints sold in the Unite...
-
Lindsay Eckenrode created an article,
What kind of brush should I use with Spartan?
A good-quality natural bristle brush works best for applying TotalBoat Spartan Bottom Paint. For simple touch-up and hard-to-reach areas, a chip brush works well. Double-thick chip brushes will lea...
-
Lindsay Eckenrode created an article,
Can you apply tung oil to penetrating epoxy?
Tung oil should not be applied over TotalBoat Penetrating Epoxy Sealer. This is not recommended. { "@context": "https://schema.org", "@type": "FAQPage", "mainEntity": [ { "@type": "Question", "name...
-
Lindsay Eckenrode created an article,
Can Penetrating Epoxy be used below the waterline?
TotalBoat Penetrating Epoxy Sealer can be used above or below the waterline. However, sealing planks on a wooden boat is not recommended unless the entire hull is completely sealed on both the insi...
-
Lindsay Eckenrode created an article,
Can Penetrating Epoxy be used below the waterline?
TotalBoat Penetrating Epoxy Sealer can be used above or below the waterline. However, sealing planks on a wooden boat is not recommended unless the entire hull is completely sealed on both the insi...
-
Lindsay Eckenrode created an article,
What is the typical coverage for TotalFair?
A two-quart kit of TotalBoat TotalFair Epoxy Fairing Compound will cover about 6.4 square feet at 1/8" thickness, not accounting for any wasted material. { "@context": "https://schema.org", "@type"...
-
Lindsay Eckenrode created an article,
For a quart of Epoxy Primer Thinner 200, how much coverage does that offer in terms of epoxy primer to thinner ratio?
If TotalBoat TotalProtect Epoxy Barrier Coat Primer or TotalBoat Aluminum Boat Barrier Coat is thinned at the maximum rate of 10%, a quart of TotalBoat Epoxy Primer Thinner 200 will thin 2.5 gallon...
-
Lindsay Eckenrode created an article,
Do you have to sand in between coats of TotalProtect?
As long as TotalBoat TotalProtect Epoxy Barrier Coat Primer is within the recoat window of 6 hours to 60 days, sanding is not required. Outside of this window, TotalProtect must be cleaned, sanded ...