• 2-part epoxy putty for repairing damaged or rotted wood
• Bonds strongly to wood and other porous substrates
• Non-sagging, non-shrinking, 100% waterproof compound
• Can be shaped, sanded, primed, painted, stained & fastened after cure
• Suitable for indoor and outdoor use; ideal for permanent non-structural repairs

TotalBoat FixWood Epoxy Putty is a durable, versatile wood repair compound designed for rebuilding, filling, and restoring damaged or rotted wood. Mixed in a simple 1:1 ratio, FixWood is easy to mold by hand or tool, stays where you put it, and cures to a solid, sandable surface that accepts fasteners, stain, paint, or primer.

Surface Preparation

Proper surface prep ensures long-lasting repairs.

• Remove dust, dirt, grease, oil, and contaminants.
• For punky or soft, rotted wood, first treat with TotalBoat Penetrating Epoxy.
• Sand repair area using 60–120 grit sandpaper.
• Remove all sanding residue before application.
• Surface must be clean, dry, and solid.

Mixing & Handling

• Wear disposable nitrile or latex gloves.
• Mix 1 part Part A (Resin) with 1 part Part B (Hardener) by volume.
• Mix by hand until the putty reaches a uniform tan color.
• Do not alter the mix ratio; mix only what you can use in 20 minutes.
• Mixed material appears as a tan, moldable putty.

Application

• Apply and shape by hand or with tools.
• Press firmly into voids to eliminate trapped air.
• Overfill slightly so the repair can be sanded smooth after curing.
• Tack free in approximately 2 hours at 72°F.
• Sandable in less than 6 hours at 72°F.
• Cures faster in warmer temperatures and slower in cooler temperatures.

Cleanup

Before Curing

• Clean tools and surfaces with acetone, denatured alcohol, or lacquer thinner.

After Curing

• Must be removed mechanically by scraping, sanding, or chiseling.

Storage

• Store at 60–90°F in a dry location.
• Keep containers tightly sealed when not in use.
• Store kits off cold floors and away from exterior walls in winter.
• Do not use material showing signs of crystallization until re-liquefied.
• To restore crystallized resin or hardener: warm to 140–150°F and stir until clear.

Safety & Handling

• Work in a well-ventilated area.
• Wear gloves, eye protection, and protective clothing.
• Avoid skin and eye contact.
• Wash thoroughly after use.
• May cause skin or respiratory allergic reactions.
• See SDS for full safety guidance.

Handling Properties