STEP 1 – PREP

• Start with a dry, clean surface.
• Be sure the surface is level before you begin.
• Place a layer of plastic sheeting or a silicone mat under your work area.
• Put on your disposable gloves and other personal protection, including safety glasses, and make sure your work area is well ventilated.

STEP 2 – MEASURE (BY VOLUME OR BY WEIGHT)

• Measure MakerPoxy by Volume: Pour 1 part resin (Part A) and 1 part hardener (Part B) into a clean, dry plastic mixing cup.
• Measure MakerPoxy by Weight:

1. MakerPoxy has a mix ratio by weight of 100A:84B.
2. Select grams on your scale.
3. Place your mixing cup on the scale and zero out the weight.
4. Add the desired amount of resin (Part A).
5. Determine the amount of hardener (Part B) by multiplying the gram weight of the resin x .84. For example, if you pour 45g of resin, you would multiply 45g x .84 to get the amount of hardener to add, which is 37.8g

• To get ready for the next step, have a second clean mixing cup nearby.

STEP 3 – MIX

• Stir slowly so you don’t get air bubbles.
• After 3-5 minutes, pour into a second cup and stir for another 2-3 minutes.

STEP 4 – ADD PIGMENTS

• Pour mixed epoxy into separate smaller mixing cups.
• Add pigments, as desired, and stir thoroughly to combine.

STEP 5 – POUR

• (Optional) Use a brush to apply a thin seal coat of clear, mixed epoxy.
• Delicate objects that may be damaged by epoxy (e.g., photographs) may need to be sealed in a clear coat before embedding.
• Pour the mixed MakerPoxy onto the surface.

STEP 6 – POP BUBBLES

• Bubbles will rise to the surface.
• Wave a heat gun quickly back and forth across the epoxy for a few seconds to pop air bubbles.
• Keep pouring and overcoating, as desired.
• Allow to cure. Full cure is 5-7 days.