Yes, TotalBoat TotalBilge Epoxy Bilge Paint can be applied over gelcoat. Be sure to follow the surface preparation instructions listed below before applying TotalBilge.
- All bare fiberglass substrates need to be fully cured for at least 5–7 days prior to any surface preparation or before applying TotalBilge.
- Do not sand the surface until all surface contamination has been removed completely.
- The surface must be properly dewaxed, or amine blush must be removed prior to any further surface preparation.
- Wash the surface with warm water and a mild soap. Dry the surface completely.
- Dewax the surface very thoroughly using TotalBoat Dewaxer & Surface Prep and clean cotton rags. Change out rags as needed to ensure that all possible wax has been removed from the substrate. This must be done thoroughly before sanding the surface, or sanding will grind the contaminant into the surface, spreading it and leading to fisheyes and potential delamination.
- Allow the surface to dry completely.
- Sand the surface with 220-grit or 320-grit sandpaper.
- Remove any sanding residue by wiping the surface clean with a clean, lint-free cotton rag wetted with one of the specified cleaner/surface preparation solvents.
- Allow the surface to dry completely before applying TotalBilge.
Comments
0 comments
Please sign in to leave a comment.