No. Recoating TotalBoat Wet Edge topside paint while the previous coat is still tacky will result in the paint not curing properly. Before recoating, always wait until the Wet Edge paint surface is no longer tacky, so you can scuff-sand it lightly, with 220-grit, to a fine powder, and wipe with a clean, lint-free rag dampened with TotalBoat Special Brushing Thinner 100 to remove sanding residue. Note that if the paint seems to grab the sandpaper while you're sanding, stop sanding and allow the surface to cure longer - even if it takes more time than specified on the product label. The dry time for Wet Edge marine paint varies based on applied film thickness, thinner and percentage used, and environmental conditions.